AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Cisco firepower 101010/22/2023 ![]() ![]() Note: When all lights are solid the firewall is operational, when the centre light is blinking, it’s still booting). Status Lights, (another reason not to put things on top of it!) Though you will notice there’s some on the back also.Reset Button: Depress for 3 seconds reverts the firewall to its factory settings, (and preserves the config apparently).Kensington Lock: Seriously? I’ve not seen one of these since about 2005, does anyone still use them?.USB Port (useful for upgrades, and backups).8 x Gigabit Ethernet ports: Normally GigabitEthernet 1/1 will be for the WAN, GigabitEthernet 1/2 though 1/8 will be for the LAN (with 1/7 and 1/8 being PoE).DHCP Scopes on both the inside and management interfaces (192.168.1.x and 192.168.45.x respectively).Management IP address 192.168.45.1 on the Management Interface.Outside IP Address set to DHCP in interface 1.Inside IP address (VLAN 1) 192.168.1.1 (on all interfaces from 2 to 8).On its factory defaults, the unit will have the following settings. ![]() If you’re here you’ve either purchased a new Cisco Firepower device running FTD (FirePower Threat Defence) or have re-imaged your Firepower device from ASA to FTD code. ![]()
0 Comments
Read More
Leave a Reply. |